Drop ceiling how to#
Drop ceiling install#
Drop ceiling professional#

There should be no gaps and the cut should be sharp looking without frays.

Re-install the ceiling tile into the grid and check the cut for straightness along the wall angle.

Using your utility knife again, run the knife along the cut edge of the ceiling tile 1 or 2 passes to the depth of the 1 st cut you made.

Using your sharp utility knife, follow the scribe line and make 2 or 3 passes only cutting about ½ way through the depth of the ceiling tile.Hold the tile down with your hand on the top of the tile and using a utility knife with your other hand, scribe a line along the wall angle making sure that you don’t allow the blade to come off the wall angle.

Drop ceiling install#

Install ceiling tile and pull the tile up to the cross tee making sure that it is square with the tee.Use a sharp utility knife and cut the ceiling tile, making about 3 or 4 passes to cut the tile all the way through.Place ceiling tile on flat surface and with that measurement scribe a line the entire length of the ceiling tile.Measure to the closest edge of the cross tee and DEDUCT 1/8”.Take 1 measurement in the center of the opening.(2) Standard 15/16” grid with a 2×2 revealed edge (drop down) ceiling tile: Tile should fit loosely but have no gaps. Install ceiling tile and check for fit.Use a sharp utility knife and cut the ceiling tile, making about 3 or 4 passes to cut all the way through.Place ceiling tile on a flat surface and using that measurement scribe a line the entire length of the ceiling tile.Measure to the closest edge of the cross tee and add 1/8”.Take 2 measurements on each side of the opening because the wall may not be straight.(1) Standard 15/16” grid with a 2×4 or 2×2 flat ceiling tile:

Drop ceiling how to#

Here is how to properly install drop ceiling tiles for the following grid and tile combinations:

Step 2 Measuring and cutting the drop ceiling border tile Determine which one you have or would like to install.

Revealed edge tiles, also called tegular or drop down tiles (Nicer dimensional look)Ĭeiling grid and tiles can be used in any of the above combinations.

Flat tiles, commonly called a square edge (Basic tile with economical look).

There are two main types of ceiling tile profiles:

The 9/16” narrow faced ceiling grid (Less commonly used).

The 15/16” wide face ceiling grid (More commonly used).

There are two main types of drop ceiling grid systems made into either a 2×4 or 2×2 pattern: It doesn’t matter if the tile is fiber-based, vinyl or wood, you just need to know what the profile of the tile is. You first need to determine what type of ceiling grid system that you have and what type of tile you will be installing. Step 1 Determining the type of drop ceiling system you haveĭrop ceiling tiles are measured and cut differently depending on the type of ceiling tile and grid system that you are installing them into. Let’s go through the proper installation methods for drop ceiling tile installation. You can carefully and meticulously install the ceiling grid and then ruin the ceiling by an unprofessional ceiling tile install.

Drop ceiling professional#

Once the room is completed, there’s always a sense of satisfaction that comes along with it.Ĭutting drop ceiling tiles can make or break your project when it comes to a professional look. It gives the ceiling that finished look that you’ve been waiting for. Installing ceiling tiles is the most rewarding part of suspended ceiling installation.